The majority of studies focus on detection of linear or monotonic trends, using

- classical t-test (for linear trends) or
- rank-based Mann–Kendall test (for monotonic trends)

typically under the assumption of uncorrelated data.

There exist two main problems:

- dependence effect, that is, the issue of inflating significance due to dependent observations when the test is developed for independent data (always check assumptions of the testing method!), and
- change points or regime shifts that affect the linear or monotonic trend hypothesis. For example, when testing the null hypothesis (\(H_0\)) of no trend against the alternative hypothesis (\(H_1\)) of linear trend, using t-test, it is easier to reject \(H_0\) and accept \(H_1\) in case A below, than in case B, and especially hard to reject \(H_0\) in case C. Case C reminds us that a test with proper alternative hypothesis should be chosen, and that non-rejection of \(H_0\) does not mean it is true.

These problems can be addressed by using tests for
**non-monotonic trends** assuming that **observations
can be autocorrelated**.

```
set.seed(777)
<- 100
n <- c(1:n)
Time <- arima.sim(list(order = c(1, 0, 0), ar = 0.5), n = n, n.start = 100, sd = 0.5)
X0 <- 2*Time/n + X0
X1 <- 2*(Time/n)^0.5 + X0
X2 <- 0.5*(Time - n/2)/n - 6*((Time - n/2)/n)^2 + X0
X3 <- as.data.frame(cbind(X0, X1, X2, X3)) X
```

The time series above were simulated:

A) `X1`

with linear trend,

B) `X2`

with square root – nonlinear monotonic – trend,
and

C) `X3`

with quadratic – nonlinear non-monotonic –
trend,

with stationary autocorrelated innovations `X0`

: \(X0_t = 0.5X0_{t-1} + e_t\), where \(e_t \sim N(0, 0.5^2)\).

Let’s test these time series using the functions from package
`funtimes`

, using significance level \(\alpha = 0.05\).

To install and load the package, run

```
install.packages("funtimes")
library(funtimes)
```

Function `notrend_test`

tests the null hypothesis of no
trend against different alternatives defined by the corresponding
tests.

Consider the following pair of hypotheses

\(H_0\): no trend

\(H_1\): linear trend

that can be tested specifically using t-test.

Assuming the time series may be autocorrelated (which is the usual
case with observational data), we apply sieve-bootstrap version of the
**t-test**, by adapting the approach of Noguchi, Gel, and Duguay (2011):

```
notrend_test(X0)
#
# Sieve-bootstrap Student's t-test for a linear trend
#
# data: X0
# Student's t value = -2.6429, p-value = 0.098
# alternative hypothesis: linear trend.
# sample estimates:
# $AR_order
# [1] 1
#
# $AR_coefficients
# phi_1
# 0.4212756
```

The large \(p\)-value correctly
indicates that there is not enough evidence to reject the hypothesis of
no trend in `X0`

in favor of the alternative hypothesis of a
linear trend.

For the other time series, \(p\)-values are reported below:

```
apply(X[,-1], 2, function(x) notrend_test(x)$p.value)
# X1 X2 X3
# 0.000 0.002 0.858
```

indicating that the null hypothesis of no trend could be rejected and
hypothesis of a linear trend could be accepted for `X1`

and
`X2`

. While `X3`

has a trend (based on the way it
was simulated and the time series plot above), the alternative
hypothesis of a linear trend does not fit in this case, so the test for
linear trend (t-test) failed to reject the null hypothesis.

Since a linear trend is also a monotonic trend, we may expect seeing
similar results when testing the following pair of hypotheses

\(H_0\): no trend

\(H_1\): monotonic trend

using Mann–Kendall test.

Apply **Mann–Kendall test**, also with the
sieve-bootstrap enhancement for potentially autocorrelated data; \(p\)-values are shown below:

```
apply(X, 2, function(x) notrend_test(x, test = "MK")$p.value)
# X0 X1 X2 X3
# 0.057 0.000 0.000 0.929
```

indicating that the null hypothesis of no trend could be rejected and
hypothesis of a monotonic trend could be accepted for `X1`

and `X2`

. For `X0`

and `X3`

, the null
hypothesis could not be rejected, because `X0`

does not have
a trend, and `X3`

has a trend that does not match the
alternative hypothesis.

If the interest is in testing for any, potentially non-monotonic
trend, consider testing the following pair of hypotheses

\(H_0\): no trend

\(H_1\): any trend

using local regression-based WAVK test (Wang,
Akritas, and Van Keilegom 2008).

Apply **WAVK test**, also with the sieve-bootstrap
enhancement for potentially autocorrelated data:

```
apply(X, 2, function(x) notrend_test(x, test = "WAVK",
factor.length = "adaptive.selection")$p.value)
# X0 X1 X2 X3
# 0.337 0.000 0.026 0.004
```

The results indicate that WAVK test was correct in non-rejecting the
null hypothesis for `X0`

, and correctly rejected it for the
time series with trends `X1`

, `X2`

, and
`X3`

.

Lyubchich, Gel, and El-Shaarawi (2013)
originally implemented *hybrid* bootstrap to this test statistic,
available from the `wavk_test`

function described in the next
section.

Function `wavk_test`

is developed for the following
goodness-of-fit question (Lyubchich, Gel, and
El-Shaarawi 2013):

\(H_0\): trend is of form \(f(\theta,t)\)

\(H_1\): trend is not of form \(f(\theta,t)\)

where \(f\) belongs to a known family
of smooth parametric functions, and \(\theta\) are its parameters.

**Note** Considering \(f(\theta,t)\) being some polynomial
function, non-rejection of the null hypothesis means that function \(f(\theta,t)\) or its simpler form
(lower-order polynomial) is sufficient for describing the trend in the
tested time series.

**Note** The case of \(f(\theta,t) \equiv 0\) corresponds to
testing for no trend (in other words, for a constant trend, same as in
the previous section), and the following code differs only in the type
of bootstrap used,

- sieve bootstrap in
`notrend_test`

(WAVK statistic is calculated on original time series and simulated autoregressive series) and - hybrid bootstrap in
`wavk_test`

(WAVK statistic is calculated on time series after the trend \(f(\theta,t)\) and autoregressive dependence are removed, and on simulated independent normal series)

```
notrend_test(X0, test = "WAVK", factor.length = "adaptive.selection") # WAVK with sieve bootstrap
#
# Sieve-bootstrap WAVK trend test
#
# data: X0
# WAVK test statistic = 8.7024, moving window = 4, p-value = 0.37
# alternative hypothesis: (non-)monotonic trend.
# sample estimates:
# $AR_order
# [1] 1
#
# $AR_coefficients
# phi_1
# 0.4212756
wavk_test(X0 ~ 0, factor.length = "adaptive.selection") # WAVK with hybrid bootstrap
#
# Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
#
# data: X0
# WAVK test statistic = 0.30965, adaptively selected window = 4, p-value
# = 0.632
# alternative hypothesis: trend is not of the form X0 ~ 0.
```

To test a linear trend \(f(\theta,t) = \theta_0 + \theta_1 t\), use

```
wavk_test(X0 ~ t, factor.length = "adaptive.selection")
#
# Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
#
# data: X0
# WAVK test statistic = -0.085378, adaptively selected window = 4,
# p-value = 0.98
# alternative hypothesis: trend is not of the form X0 ~ t.
```

Note that the time sequence `t`

is specified automatically
within the function.

For the other time series, \(p\)-values are shown below:

```
apply(X[,-1], 2, function(x) wavk_test(x ~ t, factor.length = "adaptive.selection")$p.value)
# X1 X2 X3
# 0.954 0.786 0.020
```

The function `poly`

could also be used, for example, test
quadratic trend \(f(\theta,t) = \theta_0 +
\theta_1 t + \theta_2 t^2\) and show the trend estimates using
the argument `out = TRUE`

:

```
wavk_test(X3 ~ poly(t, 2), factor.length = "adaptive.selection", out = TRUE)
#
# Trend test by Wang, Akritas, and Van Keilegom (bootstrap p-values)
#
# data: X3
# WAVK test statistic = -0.097613, adaptively selected window = 4,
# p-value = 0.896
# alternative hypothesis: trend is not of the form X3 ~ poly(t, 2).
# sample estimates:
# $trend_coefficients
# (Intercept) poly(t, 2)1 poly(t, 2)2
# -0.4860421 -0.2358495 -4.7102192
#
# $AR_order
# [1] 1
#
# $AR_coefficients
# phi_1
# 0.4193298
#
# $all_considered_windows
# Window WAVK-statistic p-value
# 4 -0.09761277 0.896
# 5 -0.47737630 0.816
# 7 -0.47880434 0.860
# 10 -0.12694875 0.780
```

This vignette belongs to R package `funtimes`

. If you wish
to cite this page, please cite the package:

```
citation("funtimes")
#
# To cite package 'funtimes' in publications use:
#
# Lyubchich V, Gel Y, Vishwakarma S (2022). _funtimes: Functions for
# Time Series Analysis_. R package version 9.0.
#
# A BibTeX entry for LaTeX users is
#
# @Manual{,
# title = {funtimes: Functions for Time Series Analysis},
# author = {Vyacheslav Lyubchich and Yulia R. Gel and Srishti Vishwakarma},
# year = {2022},
# note = {R package version 9.0},
# }
```

Lyubchich, V., Y. R. Gel, and A. El-Shaarawi. 2013. “On Detecting
Non-Monotonic Trends in Environmental Time Series: A Fusion of Local
Regression and Bootstrap.” *Environmetrics* 24 (4):
209–26. https://doi.org/10.1002/env.2212.

Noguchi, K., Y. R. Gel, and C. R. Duguay. 2011. “Bootstrap-Based
Tests for Trends in Hydrological Time Series, with Application to Ice
Phenology Data.” *Journal of Hydrology* 410 (3): 150–61.
https://doi.org/10.1016/j.jhydrol.2011.09.008.

Wang, L., M. G. Akritas, and I. Van Keilegom. 2008. “An
ANOVA-Type Nonparametric Diagnostic Test for
Heteroscedastic Regression Models.” *Journal of Nonparametric
Statistics* 20 (5): 365–82.